Experimental In Vivo Blood Clearing Device For Eliminating Viruses, Pathogens, Microbes, Bacteria, Fungi and Parasites

Revision March 16, 1996 Copyright 1991/1996 Robert C. Beck


Note: These data are Intended for Informational, Instructional, and research purposes only and are not to be construed as medical advice. Consult your licensed medical practitioner.

CHANGES since previous editions: Pulse Repetition Rate from 0.67 to ~4 Hz. (Not critical.) C2 from 1 to 0.22 microfarads. Voltage from 36 to 27 volts. Treatment time increased to 2 hours daily for 21 to 30 days. Improved electrode design and single wrist electrode placement. SW2 added to extend battery life. There are NO errors in this schematic. Hundreds have been constructed successfully when duplicated exactly without user attempted improvements.

beck0103

SPECIAL PARTS

B1: Filament type incandescent bulb, 6.3V 0.075A type 7377
(Ballast & current limiter)
Relay: 5V 50 ohm coil, PCB mount DPDT; Selecta Switch SR15P207D1
D3 & D4: Zener Diodes, 18V 1/2 watt NTE 5027A
R5: 100k ohm 1/2 watt linear potentiometer, Caltronics P-68 or equivalent
LED 1 & 2: combined as Bicolor red & green in same housing,
Radio Shack # 276-412
SW2: “Test” SPST momentary on subminiature push-button,
Radio Shack # 275-1571

beck0107

beck0108

Be Sociable, Share!

Leave a Reply

You must be logged in to post a comment.